Vertex

Vertex Impress Wolf

Vertex_Impress_Wolf_HW1_R1M_V14_20190708_SPD.zip
June 16, 2026 Vertex 1 GB Vertex

Vertex Impress Wolf is a Vertex firmware file listed under Vertex, distributed as Vertex_Impress_Wolf_HW1_R1M_V14_20190708_SPD.zip with a download size of 1 GB. It is built for Unisoc (Spreadtrum)-based devices, with a firmware build date of July 08, 2019. It is flashed with SPD ResearchDownload (or UpgradeDownload). It was published on June 16, 2026. This page has been viewed 22 times. It is available to download free of charge. Before flashing, verify the file matches your exact device model and back up your data.

File Size
1 GB
Download Free

About Vertex Impress Wolf

The Vertex Impress Wolf runs on Vertex's factory software, and sometimes you need to reinstall it from scratch. This page provides the genuine stock ROM so you can return the device to its original state. Whether an update corrupted the system or a root attempt went wrong, the factory ROM puts the Vertex Impress Wolf back to square one. File Name: Vertex_Impress_Wolf_HW1_R1M_V14_20190708_SPD.zip File Size: 1 GB Copy your data somewhere safe, top up the battery, grab a working USB cable, and confirm the proper drivers are set up before you start. When it finishes, the Vertex Impress Wolf restarts with clean factory software. Match the firmware to your variant and follow each step in order.

File Details

File nameVertex Impress Wolf
PackageVertex_Impress_Wolf_HW1_R1M_V14_20190708_SPD.zip
Brand / PlatformVertex
CategoryVertex
PlatformUnisoc (Spreadtrum)
Build dateJuly 08, 2019
Flash toolSPD ResearchDownload (or UpgradeDownload)
Package formatZIP archive
File size1 GB
Date addedJune 16, 2026
PriceFree

How to flash Vertex Impress Wolf with SPD ResearchDownload

  1. Confirm Vertex Impress Wolf matches your exact device model and that it is intended for Vertex hardware.
  2. Back up your personal data, as flashing firmware can erase the device. Charge the battery above 50%.
  3. Download the file (1 GB) using the button above and extract it on a Windows PC.
  4. Install the SPD / Unisoc USB drivers, then open SPD ResearchDownload (or UpgradeDownload).
  5. In the tool, load the .pac firmware file from the extracted folder.
  6. Start the flash, then press Start in the tool, then connect the powered-off phone while holding Volume Down (boot key).
  7. Wait for the success message before disconnecting. Leave "Erase NV" unticked unless you intend to wipe IMEI and calibration data.

Frequently asked questions

Is Vertex Impress Wolf free to download?

Yes, Vertex Impress Wolf can be downloaded free of charge from this page.

How large is the download?

The Vertex Impress Wolf package is 1 GB.

Which tool do I need to flash Vertex Impress Wolf?

Vertex Impress Wolf is Unisoc (Spreadtrum) firmware, so it is flashed with SPD ResearchDownload (or UpgradeDownload) using the .pac firmware file.

Which devices is this firmware for?

This file is intended for Vertex devices. Always confirm it matches your specific model before flashing.

More Vertex files

Back to Vertex