Lava

Lava W3

Lava_W3_SC7702_2016_FSPD.zip
June 16, 2026 Lava 14 MB Lava

Lava W3 is a Lava firmware file listed under Lava, distributed as Lava_W3_SC7702_2016_FSPD.zip with a download size of 14 MB. It is built for the Unisoc (Spreadtrum) SC7702 chipset. It is flashed with SPD ResearchDownload (or UpgradeDownload). It was published on June 16, 2026. This page has been viewed 16 times. It is available to download free of charge. Before flashing, verify the file matches your exact device model and back up your data.

File Size
14 MB
Download Free

About Lava W3

Looking for the official stock firmware for your Lava W3? You're in the right place. Below is the original Lava flash file you need to restore your device, whether you're fixing a software issue or starting fresh. Whether an update corrupted the system or a root attempt went wrong, the factory ROM puts the Lava W3 back to square one. File Name: Lava_W3_SC7702_2016_FSPD.zip File Size: 14 MB Before flashing, back up your data (the process wipes the device), charge above 50 percent, and install the correct USB drivers on your computer. After flashing, allow a few minutes for the first boot. From there the Lava W3 should run like a brand new unit.

File Details

File nameLava W3
PackageLava_W3_SC7702_2016_FSPD.zip
Brand / PlatformLava
CategoryLava
ChipsetUnisoc (Spreadtrum) SC7702
Flash toolSPD ResearchDownload (or UpgradeDownload)
Package formatZIP archive
File size14 MB
Date addedJune 16, 2026
PriceFree

How to flash Lava W3 with SPD ResearchDownload

  1. Confirm Lava W3 matches your exact device model and that the phone uses the SC7702 chipset.
  2. Back up your personal data, as flashing firmware can erase the device. Charge the battery above 50%.
  3. Download the file (14 MB) using the button above and extract it on a Windows PC.
  4. Install the SPD / Unisoc USB drivers, then open SPD ResearchDownload (or UpgradeDownload).
  5. In the tool, load the .pac firmware file from the extracted folder.
  6. Start the flash, then press Start in the tool, then connect the powered-off phone while holding Volume Down (boot key).
  7. Wait for the success message before disconnecting. Leave "Erase NV" unticked unless you intend to wipe IMEI and calibration data.

Frequently asked questions

Is Lava W3 free to download?

Yes, Lava W3 can be downloaded free of charge from this page.

How large is the download?

The Lava W3 package is 14 MB.

Which tool do I need to flash Lava W3?

Lava W3 is Unisoc (Spreadtrum) SC7702 firmware, so it is flashed with SPD ResearchDownload (or UpgradeDownload) using the .pac firmware file.

Which devices is this firmware for?

This file is intended for Lava devices. Always confirm it matches your specific model before flashing.

More Lava files

Back to Lava