Lava

Lava LN9910

Lava_LN9910_1_16_V1.0_S114_20190812_SPD.zip
June 16, 2026 Lava 904 MB Lava

Lava LN9910 is a Lava firmware file listed under Lava, distributed as Lava_LN9910_1_16_V1.0_S114_20190812_SPD.zip with a download size of 904 MB. It is built for Unisoc (Spreadtrum)-based devices, with a firmware build date of August 12, 2019. It is flashed with SPD ResearchDownload (or UpgradeDownload). It was published on June 16, 2026. This page has been viewed 10 times. It is available to download free of charge. Before flashing, verify the file matches your exact device model and back up your data.

File Size
904 MB
Download Free

About Lava LN9910

The Lava LN9910 runs on Lava's factory software, and sometimes you need to reinstall it from scratch. This page provides the genuine stock ROM so you can return the device to its original state. It can rescue a bricked handset, fix IMEI or baseband errors, and give the Lava LN9910 a fresh start without the clutter that builds up over time. File Name: Lava_LN9910_1_16_V1.0_S114_20190812_SPD.zip File Size: 904 MB Back up your files, charge the Lava LN9910 past 50 percent, install the matching drivers, and only then begin. After flashing, allow a few minutes for the first boot. From there the Lava LN9910 should run like a brand new unit.

File Details

File nameLava LN9910
PackageLava_LN9910_1_16_V1.0_S114_20190812_SPD.zip
Brand / PlatformLava
CategoryLava
PlatformUnisoc (Spreadtrum)
Build dateAugust 12, 2019
Flash toolSPD ResearchDownload (or UpgradeDownload)
Package formatZIP archive
File size904 MB
Date addedJune 16, 2026
PriceFree

How to flash Lava LN9910 with SPD ResearchDownload

  1. Confirm Lava LN9910 matches your exact device model and that it is intended for Lava hardware.
  2. Back up your personal data, as flashing firmware can erase the device. Charge the battery above 50%.
  3. Download the file (904 MB) using the button above and extract it on a Windows PC.
  4. Install the SPD / Unisoc USB drivers, then open SPD ResearchDownload (or UpgradeDownload).
  5. In the tool, load the .pac firmware file from the extracted folder.
  6. Start the flash, then press Start in the tool, then connect the powered-off phone while holding Volume Down (boot key).
  7. Wait for the success message before disconnecting. Leave "Erase NV" unticked unless you intend to wipe IMEI and calibration data.

Frequently asked questions

Is Lava LN9910 free to download?

Yes, Lava LN9910 can be downloaded free of charge from this page.

How large is the download?

The Lava LN9910 package is 904 MB.

Which tool do I need to flash Lava LN9910?

Lava LN9910 is Unisoc (Spreadtrum) firmware, so it is flashed with SPD ResearchDownload (or UpgradeDownload) using the .pac firmware file.

Which devices is this firmware for?

This file is intended for Lava devices. Always confirm it matches your specific model before flashing.

More Lava files

Back to Lava