Lava

Lava 4G Connect M1

Lava_4G_Connect_M1_S109_171120_SPD.zip
June 16, 2026 Lava 368 MB Lava

Lava 4G Connect M1 is a Lava firmware file listed under Lava, distributed as Lava_4G_Connect_M1_S109_171120_SPD.zip with a download size of 368 MB. It is built for Unisoc (Spreadtrum)-based devices. It is flashed with SPD ResearchDownload (or UpgradeDownload). It was published on June 16, 2026. This page has been viewed 8 times. It is available to download free of charge. Before flashing, verify the file matches your exact device model and back up your data.

File Size
368 MB
Download Free

About Lava 4G Connect M1

Looking for the official stock firmware for your Lava 4G Connect M1? You're in the right place. Below is the original Lava flash file you need to restore your device, whether you're fixing a software issue or starting fresh. Whether an update corrupted the system or a root attempt went wrong, the factory ROM puts the Lava 4G Connect M1 back to square one. File Name: Lava_4G_Connect_M1_S109_171120_SPD.zip File Size: 368 MB Copy your data somewhere safe, top up the battery, grab a working USB cable, and confirm the proper drivers are set up before you start. Once installed, your Lava 4G Connect M1 should boot up like new. Use the right file for your exact model and don't interrupt the process.

File Details

File nameLava 4G Connect M1
PackageLava_4G_Connect_M1_S109_171120_SPD.zip
Brand / PlatformLava
CategoryLava
PlatformUnisoc (Spreadtrum)
Flash toolSPD ResearchDownload (or UpgradeDownload)
Package formatZIP archive
File size368 MB
Date addedJune 16, 2026
PriceFree

How to flash Lava 4G Connect M1 with SPD ResearchDownload

  1. Confirm Lava 4G Connect M1 matches your exact device model and that it is intended for Lava hardware.
  2. Back up your personal data, as flashing firmware can erase the device. Charge the battery above 50%.
  3. Download the file (368 MB) using the button above and extract it on a Windows PC.
  4. Install the SPD / Unisoc USB drivers, then open SPD ResearchDownload (or UpgradeDownload).
  5. In the tool, load the .pac firmware file from the extracted folder.
  6. Start the flash, then press Start in the tool, then connect the powered-off phone while holding Volume Down (boot key).
  7. Wait for the success message before disconnecting. Leave "Erase NV" unticked unless you intend to wipe IMEI and calibration data.

Frequently asked questions

Is Lava 4G Connect M1 free to download?

Yes, Lava 4G Connect M1 can be downloaded free of charge from this page.

How large is the download?

The Lava 4G Connect M1 package is 368 MB.

Which tool do I need to flash Lava 4G Connect M1?

Lava 4G Connect M1 is Unisoc (Spreadtrum) firmware, so it is flashed with SPD ResearchDownload (or UpgradeDownload) using the .pac firmware file.

Which devices is this firmware for?

This file is intended for Lava devices. Always confirm it matches your specific model before flashing.

More Lava files

Back to Lava