Intex

Intex Aqua Q7 Pro

Intex_Aqua_Q7_Pro_V05_Indian_SER_SPD.zip
June 16, 2026 Intex 513 MB Intex

Intex Aqua Q7 Pro is a Intex firmware file listed under Intex, distributed as Intex_Aqua_Q7_Pro_V05_Indian_SER_SPD.zip with a download size of 513 MB. It is built for Unisoc (Spreadtrum)-based devices. It is flashed with SPD ResearchDownload (or UpgradeDownload). It was published on June 16, 2026. This page has been viewed 4 times. It is available to download free of charge. Before flashing, verify the file matches your exact device model and back up your data.

File Size
513 MB
Download Free

About Intex Aqua Q7 Pro

If your Intex Aqua Q7 Pro has been giving you trouble, reinstalling the stock firmware is often the cleanest fix. Here you'll find the full Intex flash package along with the details to check before you begin. It can rescue a bricked handset, fix IMEI or baseband errors, and give the Intex Aqua Q7 Pro a fresh start without the clutter that builds up over time. File Name: Intex_Aqua_Q7_Pro_V05_Indian_SER_SPD.zip File Size: 513 MB Back up everything important first, keep the battery above the halfway mark, use a cable you trust, and make sure the right drivers are installed. When it finishes, the Intex Aqua Q7 Pro restarts with clean factory software. Match the firmware to your variant and follow each step in order.

File Details

File nameIntex Aqua Q7 Pro
PackageIntex_Aqua_Q7_Pro_V05_Indian_SER_SPD.zip
Brand / PlatformIntex
CategoryIntex
PlatformUnisoc (Spreadtrum)
Flash toolSPD ResearchDownload (or UpgradeDownload)
Package formatZIP archive
File size513 MB
Date addedJune 16, 2026
PriceFree

How to flash Intex Aqua Q7 Pro with SPD ResearchDownload

  1. Confirm Intex Aqua Q7 Pro matches your exact device model and that it is intended for Intex hardware.
  2. Back up your personal data, as flashing firmware can erase the device. Charge the battery above 50%.
  3. Download the file (513 MB) using the button above and extract it on a Windows PC.
  4. Install the SPD / Unisoc USB drivers, then open SPD ResearchDownload (or UpgradeDownload).
  5. In the tool, load the .pac firmware file from the extracted folder.
  6. Start the flash, then press Start in the tool, then connect the powered-off phone while holding Volume Down (boot key).
  7. Wait for the success message before disconnecting. Leave "Erase NV" unticked unless you intend to wipe IMEI and calibration data.

Frequently asked questions

Is Intex Aqua Q7 Pro free to download?

Yes, Intex Aqua Q7 Pro can be downloaded free of charge from this page.

How large is the download?

The Intex Aqua Q7 Pro package is 513 MB.

Which tool do I need to flash Intex Aqua Q7 Pro?

Intex Aqua Q7 Pro is Unisoc (Spreadtrum) firmware, so it is flashed with SPD ResearchDownload (or UpgradeDownload) using the .pac firmware file.

Which devices is this firmware for?

This file is intended for Intex devices. Always confirm it matches your specific model before flashing.

More Intex files

Back to Intex