Intex

Intex Aqua Power II

Intex_Aqua_Power_II_V10_Indian_SER_SPD.zip
June 16, 2026 Intex 572 MB Intex

Intex Aqua Power II is a Intex firmware file listed under Intex, distributed as Intex_Aqua_Power_II_V10_Indian_SER_SPD.zip with a download size of 572 MB. It is built for Unisoc (Spreadtrum)-based devices. It is flashed with SPD ResearchDownload (or UpgradeDownload). It was published on June 16, 2026. This page has been viewed 6 times. It is available to download free of charge. Before flashing, verify the file matches your exact device model and back up your data.

File Size
572 MB
Download Free

About Intex Aqua Power II

The Intex Aqua Power II runs on Intex's factory software, and sometimes you need to reinstall it from scratch. This page provides the genuine stock ROM so you can return the device to its original state. Whether an update corrupted the system or a root attempt went wrong, the factory ROM puts the Intex Aqua Power II back to square one. File Name: Intex_Aqua_Power_II_V10_Indian_SER_SPD.zip File Size: 572 MB Copy your data somewhere safe, top up the battery, grab a working USB cable, and confirm the proper drivers are set up before you start. Once installed, your Intex Aqua Power II should boot up like new. Use the right file for your exact model and don't interrupt the process.

File Details

File nameIntex Aqua Power II
PackageIntex_Aqua_Power_II_V10_Indian_SER_SPD.zip
Brand / PlatformIntex
CategoryIntex
PlatformUnisoc (Spreadtrum)
Flash toolSPD ResearchDownload (or UpgradeDownload)
Package formatZIP archive
File size572 MB
Date addedJune 16, 2026
PriceFree

How to flash Intex Aqua Power II with SPD ResearchDownload

  1. Confirm Intex Aqua Power II matches your exact device model and that it is intended for Intex hardware.
  2. Back up your personal data, as flashing firmware can erase the device. Charge the battery above 50%.
  3. Download the file (572 MB) using the button above and extract it on a Windows PC.
  4. Install the SPD / Unisoc USB drivers, then open SPD ResearchDownload (or UpgradeDownload).
  5. In the tool, load the .pac firmware file from the extracted folder.
  6. Start the flash, then press Start in the tool, then connect the powered-off phone while holding Volume Down (boot key).
  7. Wait for the success message before disconnecting. Leave "Erase NV" unticked unless you intend to wipe IMEI and calibration data.

Frequently asked questions

Is Intex Aqua Power II free to download?

Yes, Intex Aqua Power II can be downloaded free of charge from this page.

How large is the download?

The Intex Aqua Power II package is 572 MB.

Which tool do I need to flash Intex Aqua Power II?

Intex Aqua Power II is Unisoc (Spreadtrum) firmware, so it is flashed with SPD ResearchDownload (or UpgradeDownload) using the .pac firmware file.

Which devices is this firmware for?

This file is intended for Intex devices. Always confirm it matches your specific model before flashing.

More Intex files

Back to Intex