Qmobile i8i Plus
Qmobile i8i Plus is a Qmobile firmware file listed under Qmobile, distributed as Qmobile_i8i_Plus_MT6580_20190420_8.1.0.zip.zip.zip with a download size of 1 GB. It is built for the MediaTek MT6580 chipset and runs Android 8.1 (Oreo), with a firmware build date of April 20, 2019. It is flashed with SP Flash Tool. It was published on June 16, 2026. This page has been viewed 16 times. It is available to download free of charge. Before flashing, verify the file matches your exact device model and back up your data.
About Qmobile i8i Plus
Looking for the official stock firmware for your Qmobile i8i Plus? You're in the right place. Below is the original Qmobile flash file you need to restore your device, whether you're fixing a software issue or starting fresh. Whether an update corrupted the system or a root attempt went wrong, the factory ROM puts the Qmobile i8i Plus back to square one. File Name: Qmobile_i8i_Plus_MT6580_20190420_8.1.0.zip.zip.zip File Size: 1 GB Back up everything important first, keep the battery above the halfway mark, use a cable you trust, and make sure the right drivers are installed. After flashing, allow a few minutes for the first boot. From there the Qmobile i8i Plus should run like a brand new unit.
File Details
| File name | Qmobile i8i Plus |
|---|---|
| Package | Qmobile_i8i_Plus_MT6580_20190420_8.1.0.zip.zip.zip |
| Brand / Platform | Qmobile |
| Category | Qmobile |
| Chipset | MediaTek MT6580 |
| Android version | Android 8.1 (Oreo) |
| Build date | April 20, 2019 |
| Flash tool | SP Flash Tool |
| Package format | ZIP archive |
| File size | 1 GB |
| Date added | June 16, 2026 |
| Price | Free |
How to flash Qmobile i8i Plus with SP Flash Tool
- Confirm Qmobile i8i Plus matches your exact device model and that the phone uses the MT6580 chipset.
- Back up your personal data, as flashing firmware can erase the device. Charge the battery above 50%.
- Download the file (1 GB) using the button above and extract it on a Windows PC.
- Install the MediaTek VCOM / USB drivers, then open SP Flash Tool.
- In the tool, load the scatter file (MTxxxx_Android_scatter.txt) from the extracted folder.
- Start the flash, then power the phone off, then connect it (hold Volume Up or Down if it is not detected).
- Wait for the success message before disconnecting. Use "Download Only" — "Format All + Download" erases IMEI/NVRAM calibration.
Guides for this firmware
- MT6580 Firmware Guide: Flashing Tools and SafetyThe MT6580 is a MediaTek chipset used in a wide variety of entry-level Android smartphones and tablets. To reflash or unbrick a device using this chipset, you will need the correct firmware package…
- Installing MediaTek VCOM Drivers for SP Flash ToolTo flash firmware on a MediaTek-based device, you must use the SP Flash Tool in conjunction with MediaTek VCOM USB drivers. These drivers allow your computer to communicate with the device's chipset…
- What is a Scatter File? Loading MediaTek Firmware in SP Flash ToolA scatter file is a text document, typically named MTxxxx_Android_scatter.txt , that acts as a map for the SP Flash Tool. It tells the software exactly where each partition of the firmware should be…
Frequently asked questions
Is Qmobile i8i Plus free to download?
Yes, Qmobile i8i Plus can be downloaded free of charge from this page.
How large is the download?
The Qmobile i8i Plus package is 1 GB.
Which tool do I need to flash Qmobile i8i Plus?
Qmobile i8i Plus is MediaTek MT6580 firmware, so it is flashed with SP Flash Tool using the scatter file (MTxxxx_Android_scatter.txt).
What Android version is Qmobile i8i Plus?
This firmware is Android 8.1 (Oreo), built on April 20, 2019.
Which devices is this firmware for?
This file is intended for Qmobile devices. Always confirm it matches your specific model before flashing.